Its wise have your chimney inspected by
an expert to check and know if the bricks are broken within.
It is not uncommon for brick chimneys
to crumble with age. Chimneys are typically positioned in exposed
areas of the roof, and crumbling will occur attributable to
weathering albeit alternative masonry around your house is in
physical fitness. In most cases, a crumbling chimney means that the
mortar between the bricks did get out the joints, the bricks did
crack, or both. Repair a chimney that has began to crumble could be a
task most householders will do themselves. typically it needs you to
mix the mortar and replace any broken bricks.
1
Measure the length of the broken
irregular bricks within the chimney. Bricks that are custom-cut would
force you to chop the new brick to suit.
2
Mark the measuring of the recent bricks
on your new brick employing a marker.
3
Put on safety glasses and work gloves.
Chip a groove on the lines you marked within the brick employing a
set chisel and a hammer.
4
Insert a brick set into the groove, and
strike the tip with the hammer to separate the brick at your mark.
Continue cutting the remaining bricks within the same manner.
5
Chisel out the mortar round the broken
brick to a depth of a minimum of 1/2 in., exploitation the hammer and
chisel. Move the chime in on the joint, removing one of the mortar
at a time. Make sure to clean properly the joints with a wire brush
as you\'re employed.
6
Pull every brick because it loosens
from the chimney and set it aside. don\'t take away too several
bricks from the chimney at only once. Instead, repair the chimney bit
by bit, removing solely a few of bricks at a time. Once one space is
repaired, it\'ll support the structure as you tackle consecutive.
7
Mix your mortar in step with the
manufacturer’s label directions. build just enough to figure for
fifteen to twenty minutes at a time.
8
Dampen the brick with a sponge. Apply
the mortar into the empty areas in a very layer that\'s an equivalent
thickness as adjacent joints.
9
Trowel a layer of mortar onto the
highest and ends of the replacement brick, and place the brick into
the mortared house.
10
Scrape away excess mortar with the
trowel. form the wet mortar with the trowel so it matches the looks
of the adjacent joints.
11
Continue applying mortar into the gaps
or sections and replace the brick till all the broken bricks are
replaced.
12
Allow the mortar to dry for regarding
Associate in Nursing hour. Wipe the surplus mortar from the
encircling brick with a humid sponge.
Repointing Crumbling Mortar
1
Chisel cracked or crumbling mortar from
the joints with a hammer and set chisel. Clean every joint of loose
mortar and dirt with a wire brush.
2
Mix your mortar in step with the
manufacturer’s label directions. build just enough to figure for
fifteen to twenty minutes at a time. Usually, mortar is mixed at a
quantitative relation of two components sand to one half cement.
Water is another till you deliver the goods a pasty consistency.
3
Pour the mortar into a mortar bag.
Place the mortar into the clean out joints, and squeeze to push the
mortar through the nozzle to fill the joint.
4
Scrape the surplus mortar from the
chimney employing a trowel, and form it therefore it matches the
adjacent joints.
5
Allow the mortar to dry for regarding
Associate in Nursing hour. Wipe the surplus mortar from the
encircling brick with a humid sponge.
Things You can want
Ladder
Measuring tape
Marker
Safety glasses
Gloves
Hammer
Cold chisel
Brick set
Bucket
Mortar mix
Water
Trowel
Wire brush
Mortar bag
Sponge
.jpg)
